[IBIS-Users] difference between [Pullup Reference] and [Voltage Range]

From: Akhilesh CHANDRA <akhilesh.chandra_at_.....>
Date: Thu Apr 21 2005 - 06:55:58 PDT
>
>
Hello Friends,

 As I read in IBIS standard

Voltage Range----Defines the power supply voltage tolerance over which 
the model is intended to operate.
Pullup Reference--Defines a voltage rail other than that defined by the 
[Voltage  Range] keyword as the reference voltage for the [Pullup] I-V  
data.

  My buffer have dual supply VDD and VDDE2V5. VDD is the core side 
supply and VDDE2V5 voltage at the pad as well as voltage at the pullup 
and power clam diode.

 I wnat to know how this information is use in the simulation.
 When pullup information is present then it's overwrite voltag information?

I have given
[Voltage Range]  1.2 1.1 1.3
[Pullup Reference] 2.5 2.2 2.7

   Which information is used in the simulation.

Regards
Akhilesh

|------------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with just the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a written request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda.org/pub/ibis/email_archive/  Recent
|  http://www.eda.org/pub/ibis/users_archive/  Recent
|  http://www.eda.org/pub/ibis/email/          E-mail since 1993
Received on Thu Apr 21 06:56:15 2005

This archive was generated by hypermail 2.1.8 : Thu Apr 21 2005 - 07:01:37 PDT