Re: [IBIS-Users] rising waveform

> I also had a similar problem sometime back. And the way to resolve is to
> increase the simulation time.
> In your case, a small increase in sim time should do the job.

Probably not in this case.  This case is different.

The final endpoint has an error of only 0.01%.  It is the starting point
that is off and is triggering the warning message.

I think the other reasons cited by Tom Dagostino are where you should look.

Another possibility is that the leading edge of the V/T data was manually
truncated, and a little too much of it was cut off.

Regards,
Andy

|------------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with just the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a written request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda.org/pub/ibis/email_archive/  Recent
|  http://www.eda.org/pub/ibis/users_archive/  Recent
|  http://www.eda.org/pub/ibis/email/          E-mail since 1993