[IBIS-Users] Gigabit Ethernet

From: Raul Moreira <raul_at_.....>
Date: Wed Nov 16 2005 - 06:16:15 PST
 

            It is my high-speed design.

 

            I would to know if anyone could help me about how to route
differential pairs of a Gigabit Ethernet Interface. About PCB routing rules,
from Ethernet controller to Ethernet connector. I designed a co-layer
solution with Realtek RTL8100C (Fast Ethernet controller) and RTL8110SB
(Gigabit Ethernet Controller).

 

            I donīt have the Ethernet Controller IBIS file (the Ethernet
interface pins are not included on the IBIS supplied by Realtek). But, I
took a SPICE model from Connector datasheet (pulse Jack).

 

            I work with Allegro SPB15.5 with SI tools.

 

Trusting in your help,

 

            Raul Moreira

 

            HW & SI Engineer

 



|------------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with just the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a written request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda.org/pub/ibis/email_archive/  Recent
|  http://www.eda.org/pub/ibis/users_archive/  Recent
|  http://www.eda.org/pub/ibis/email/          E-mail since 1993
Received on Wed Nov 16 06:16:58 2005

This archive was generated by hypermail 2.1.8 : Wed Nov 16 2005 - 06:20:45 PST