Venu, Thanks for your interest in IBIS. After looking at the waveforms and parser output, I have a few comments: 1) I strongly agree with Itzik that the min corner V-t tables should be allowed to settle to their final DC level to remove I-V/V-t mismatches. 2) The ground clamp table is highly discontinuous. While this shouldn't cause problems in the operating region, I cannot vouch for what tools will do to or with the summed data when the pulldown and ground clamp tables are added together to drive. You may wish to add some data points (the table contains fewer than 50) or recheck your extraction procedure for that device state. 3) I note that the voltage ordering for the pulldown and ground clamp tables is positive-to-negative. This is perfectly legal in IBIS, but I recall this has caused simulators some trouble in the distant past. Have you tried reordering these negative-to-positive and checking the results? 4) To clarify, are you using a test load with a capacitor *before* the transmission line? Is there a reason your test load includes this unusual structure? 5) Please ensure that your SPICE tool is using all the V-t tables available (some tools feature a setting for a number of rising and/or falling tables -- ensure this is set to use all 4 present in your model). 6) (minor point) You may wish to make use of the [Test Load] and [Test Data] keywords to include your loading and correlation waveform information from your SPICE tool, to ease comparison. 7) One last question: how does the correlation look into a capacitor alone (both values) and a transmission line alone? If these match well, I would inquire with your vendor about checking the algorithm used for a mixed load like this one. Good luck! - Michael Mirmak Intel Corp. |------------------------------------------------------------------ |For help or to subscribe/unsubscribe, email majordomo@eda.org |with just the appropriate command message(s) in the body: | | help | subscribe ibis <optional e-mail address, if different> | subscribe ibis-users <optional e-mail address, if different> | unsubscribe ibis <optional e-mail address, if different> | unsubscribe ibis-users <optional e-mail address, if different> | |or email a written request to ibis-request@eda.org. | |IBIS reflector archives exist under: | | http://www.eda.org/pub/ibis/email_archive/ Recent | http://www.eda.org/pub/ibis/users_archive/ Recent | http://www.eda.org/pub/ibis/email/ E-mail since 1993Received on Tue Dec 20 10:20:09 2005
This archive was generated by hypermail 2.1.8 : Tue Dec 20 2005 - 10:22:07 PST