RE: [IBIS-Users] no convergence in dc sweep

From: <seshadri.kirankumar_at_.....>
Date: Wed Aug 02 2006 - 03:00:09 PDT
Hi ,

     For this you can use below solutions

1)       increase ITL1 (this increase the no.of iterations for getting
operating point so that simulation will proceed) because reducing step
size is not proper as it is limited to 100 points based on the range

2)       if you are facing problem other than 1 st point value (prints
data for few steps of  PAD voltage and stops because of  convergence)
increase ITL2 which is DC transfer curve iterations

3)       instead of giving as entire range say

        .DC  VPAD  -1.8   3.6     0.06

You can print all PAD current steps individually using . RERUN statement
each for each VPAD step value but here some manual work is required.



Regards

Kiran Kumar





________________________________

From: owner-ibis-users@server.eda-stds.org
[mailto:owner-ibis-users@server.eda-stds.org] On Behalf Of Nekkondi,
Hima
Sent: Wednesday, August 02, 2006 2:41 PM
To: ibis-users@server.eda-stds.org; ibis@server.eda-stds.org
Subject: [IBIS-Users] no convergence in dc sweep



hi,



   when i am running the spice simulation for me this eror came



   error  : no convergence in dc sweep curves at  -2.5000



    can any one tell me why  this error came and how to debug.



Regards,

Hima.








The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain proprietary, confidential or privileged information. If you are not the intended recipient, you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately and destroy all copies of this message and any attachments.

WARNING: Computer viruses can be transmitted via email. The recipient should check this email and any attachments for the presence of viruses. The company accepts no liability for any damage caused by any virus transmitted by this email.

www.wipro.com
--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Wed Aug 2 03:05:08 2006

This archive was generated by hypermail 2.1.8 : Wed Aug 02 2006 - 03:06:21 PDT