[IBIS-Users] Differential Output terminals

From: Fabio BRINA <fabio.brina_at_.....>
Date: Mon May 19 2008 - 05:21:59 PDT
Hello ibis experts,
 
I'm in the modeling of a "fully differential driver"
structure, do you think I have to consider the 
same model for both output terminals?
(I see many differential model in this way)
 
[Pin]
...
11   DOUT3-    OUTMOD
12   DOUT3+    OUTMOD
...
 
or is better to consider two model for the two output?
 
[Pin]
...
11   DOUT3-    OUTMINUS
12   DOUT3+    OUTPLUS
...
 
(in this case the [Pulldown] table of OUTMINUS have the 
 same points od [Pullup] table of OUTPLUS and viceversa?)
 
Many thanks,
Regards,
 
Fabio Brina

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.



--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Mon May 19 05:22:55 2008

This archive was generated by hypermail 2.1.8 : Mon May 19 2008 - 05:24:17 PDT