Hi All, I am getting following error when I run IBIS parser, ERROR - Model drv_out: The [Falling Waveform] with [R_fixture]=50 Ohms and [V_fixture]=2.5V has TYP column DC endpoints of 0.50V and 2.50v, but an equivalent load applied to the model's I-V tables yields different voltages (-0.59V and 0.63V), a difference of 89.46% and 153.09%, respectively. I appreciate suggestions or documents to find the solution for this problem. Thanks, -Babid. -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -------------------------------------------------------------------- |For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org |with the appropriate command message(s) in the body: | | help | subscribe ibis <optional e-mail address, if different> | subscribe ibis-users <optional e-mail address, if different> | unsubscribe ibis <optional e-mail address, if different> | unsubscribe ibis-users <optional e-mail address, if different> | |or e-mail a request to ibis-request@eda-stds.org. | |IBIS reflector archives exist under: | | http://www.eda-stds.org/pub/ibis/email_archive/ Recent | http://www.eda-stds.org/pub/ibis/users_archive/ Recent | http://www.eda-stds.org/pub/ibis/email/ E-mail since 1993Received on Wed Jul 9 11:13:11 2008
This archive was generated by hypermail 2.1.8 : Wed Jul 09 2008 - 11:13:57 PDT