Girija, The information you supplied is not sufficient to determine the problem you have. If this is a HyperLynx problem, I would suggest to contact your nearest Mentor support people. If it is a model problem, contact the model maker’s support people. Thanks, Arpad =============================================================== From: owner-ibis-users@eda.org [mailto:owner-ibis-users@eda.org] On Behalf Of Girija V Chougala Sent: Thursday, May 29, 2014 7:25 AM To: ibis-users@eda.org Cc: ibis-info@eda.org Subject: [IBIS-Users] Issue with LVPECL output Hi All, I have tried using 5p49v5901 (versaClock@5 ) IBIS model. I'm trying to observe LVPECL outputs with proper termination. Hyperlynx tool is used for simulation. Snapshot of the schematic and simulation output are attached. The LVPECL output is not at all differential output. VOH , VOL are secondary concern. Could anybody suggest what is wrong here. A quick reply would be highly appreciated. Thanks, Girija This message and any attachments may contain Cypress (or its subsidiaries) confidential information. If it has been received in error, please advise the sender and immediately delete this message. -- This message has been scanned for viruses and dangerous content by MailScanner<http://www.mailscanner.info/>, and is believed to be clean. -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -------------------------------------------------------------------- |For help or to subscribe/unsubscribe, e-mail mikelabonte@eda-stds.org |or ibis-request@eda-stds.org | |IBIS reflector archives exist under: | | http://www.eda-stds.org/ibis/email_archive/ Recent | http://www.eda-stds.org/ibis/users_archive/ Recent | http://www.eda-stds.org/ibis/email/ E-mail since 1993Received on Thu May 29 06:25:44 2014
This archive was generated by hypermail 2.1.8 : Thu May 29 2014 - 06:26:11 PDT