[IBIS-Users] Modeling of Capacitance in Differential Receiver

From: Manish BANSAL <manish-ftm.bansal@st.com>
Date: Thu Dec 04 2014 - 05:12:32 PST
Hello All,

I have a differential receiver as  following where there is capacitance (Cmid shown in Fig.) connected to the middle of the termination resistance with ground.

[cid:image002.png@01D00FF2.106AC780][cid:image004.png@01D00FF2.106AC780]Is there any method to model this capacitance in IBIS ?

















Thanks & Regards,
Manish

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.




--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail mikelabonte@eda-stds.org
|or ibis-request@eda-stds.org
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/ibis/email_archive/ Recent
|  http://www.eda-stds.org/ibis/users_archive/ Recent
|  http://www.eda-stds.org/ibis/email/         E-mail since 1993
image002.png
image004.png
Differential_Rx.png
Received on Thu Dec 4 05:13:04 2014

This archive was generated by hypermail 2.1.8 : Thu Dec 04 2014 - 05:13:46 PST