From owner-ibis-users@eda.org Fri Nov  2 08:35:47 2001
Received: by server.eda.org (8.12.0.Beta7/8.12.0.Beta7) id fA2GZ7aM021328;
	Fri, 2 Nov 2001 08:35:07 -0800 (PST)
Reply-To: <jpowell@innoveda.com>
From: "Jon Powell" <jpowell@innoveda.com>
To: "'whiz kid'" <we_r_frendz@yahoo.com>, <ibis_users@eda.org>
Cc: <ibis-users@eda.org>
Subject: RE: Question about IBIS model.
Date: Fri, 2 Nov 2001 08:31:40 -0800
Message-ID: <001901c163bb$da15cae0$0301a8c0@pcjpowell>
MIME-Version: 1.0
Content-Type: text/plain;
	charset="us-ascii"
Content-Transfer-Encoding: 7bit
X-Priority: 3 (Normal)
X-MSMail-Priority: Normal
X-Mailer: Microsoft Outlook CWS, Build 9.0.2416 (9.0.2910.0)
X-MimeOLE: Produced By Microsoft MimeOLE V5.50.4807.1700
Importance: Normal
In-Reply-To: <20011102032728.50000.qmail@web20707.mail.yahoo.com>
Sender: owner-ibis-users@eda.org
Precedence: bulk

If you know the value of the internal pull-up, you can just subtract the
linear thevinen values from the IV curve of the total component.

jon


> -----Original Message-----
> From: owner-ibis-users@eda.org [mailto:owner-ibis-users@eda.org]On
> Behalf Of whiz kid
> Sent: Thursday, November 01, 2001 7:27 PM
> To: ibis_users@eda.org
> Cc: ibis-users@eda.org
> Subject: Question about IBIS model.
> 
> 
> Hi Folks,
> I have a open drain model with built in pullup
> resistor. I need to create a similar model but with
> out the internal pullup. I would really appreciate if
> any of you can suggest as to how I need to approach
> this.
> 
> Thanks in Advance.
> Rahul.
> 
> __________________________________________________
> Do You Yahoo!?
> Find a job, post your resume.
> http://careers.yahoo.com
>