Question on the Sweep range

After reading all the ibis specs that are available to me, I can not find this
answer anywhere.

For the voltage ranges, version 1.1 and 2.0 specs state:

2) Voltage Ranges:
| Points for each curve must span the voltages listed below:
|
| Curve Low Voltage High Voltage
| ----------- ----------- ------------
| [Pulldown] GND - POWER POWER + POWER
| [Pullup] GND - POWER POWER + POWER
| [GND Clamp] GND - POWER GND + POWER
| [POWER Clamp] POWER POWER + POWER

Now the question I have is this. When you are sweeping on the non-typical
voltage, what is the range. Meaning, if you have a 5 volt power supply,
with a minimum voltage of 4.5 volts. Does you sweep for the pullup now go from
-4.5 volts to 9 volts? or from -5 to 5 as before?

Thanks in advance,

Scott Aron Bloom
InterConnectiX, Inc.
Received on Mon Jun 27 10:10:50 1994