[IBIS] Different PMOS and NMOS driver impedence

From: Chetana Raghuwanshi <chetana.raghuwanshi_at_.....>
Date: Mon Aug 18 2008 - 06:07:18 PDT
Hello Experts,

One of my IO cell has a buffer with different PMOS  and NMOS impedences.
PMOS impedence is approx 200 Ohms and that for NMOS is 96 Ohms.
In this case what should be the value of Rfixture for calculating IV VT
curves ?
Would it be Rfixture1 for calculating  pull down and falling waveforms and
Rfixture2 for  calculating  pull up and rising waveforms ?
If I do rise/pullup and  fall/pulldown simulations with different Rfixture
values, is it acceptable ?

Best Regards
Chetana

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.



--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Mon Aug 18 06:04:40 2008

This archive was generated by hypermail 2.1.8 : Mon Aug 18 2008 - 06:06:15 PDT