enable vrs input for 3-state model

Hi IBIS Gurus!

Could anybody answer my question about 3-state model,
which has enable-pin? I assume it also has an input-pin.
We use either ramp or Raising/Falling waveforms
to model change in output if input changes.
How about enable-pin? How fast the output is going to
high impedance state if enable-pin gets a signal to go
from enable to disable state (or vise verse).

Thank you very much

 Nikolai Bannov
 Analysis Products Division
 Avant! Corporation
Received on Tue Jun 23 17:11:22 1998