Nik,
It should not matter whether the output is turned on/off high/low by the
enable
or input signal. The only difference is in the logic.
Arpad
============================================================================
===
Hi IBIS Gurus!
Could anybody answer my question about 3-state model,
which has enable-pin? I assume it also has an input-pin.
We use either ramp or Raising/Falling waveforms
to model change in output if input changes.
How about enable-pin? How fast the output is going to
high impedance state if enable-pin gets a signal to go
from enable to disable state (or vise verse).
Thank you very much
Nikolai Bannov
Analysis Products Division
Avant! Corporation
Received on Wed Jun 24 11:54:04 1998
This archive was generated by hypermail 2.1.8 : Fri Jun 03 2011 - 09:53:46 PDT