Check for 'warnings' in your .out files. You may see a lot of conververge issues
that SPICE tries to solve. These could lead to the incorrect data points..
Check to see if the datapoints in the .out file makes sense.
You should also be using s2ibis2_fix and not s2ibis.
Regards,
Syed
Cisco Systems, Inc
>
> > Hello,
>
> > I'm using s2ibis to generate ibis models and I'm new to IBIS.
> > The ramp data and all the rising & falling curves look like this. There were
> > no errors or aborted simulations. All the .out files seem to have all the
> > datapoints.
> > The pull-up, pull-down, power & ground clamp curves seem to be fine.
> > Where am I going wrong?
>
> > Thanks
> > Prabhu
>
> > [Ramp]
> > | variable typ min max
> > dV/dt_r -2.470e-21/0.000 -3.257e-21/0.000 -1.816e-21/0.000
> > dV/dt_f 2.470e-21/0.000 3.257e-21/0.000 1.816e-21/0.000
> > R_load = 50.0000
> > |
> > [Rising Waveform]
> > R_fixture = 50.0000
> > V_fixture = 3.3000
> > V_fixture_min = 3.0000
> > V_fixture_max = 3.6000
> > | time V(typ) V(min) V(max)
> > |
> > 0.000S NA NA NA
> > 0.000S NA NA NA
> > 0.000S NA NA NA
> > 0.000S NA NA NA
> > 0.000S NA NA NA
> > 0.000S NA NA NA
> > 0.000S NA NA NA
>
> > ...
>
> > :-)
> > Prabhu Mohan
> > Product Engineer
> > Actel Corp.
> > 408.522.4412 - work
>
Received on Wed May 23 14:11:51 2001
This archive was generated by hypermail 2.1.8 : Fri Jun 03 2011 - 09:53:47 PDT