Subject: [IBIS-Users] number of waveforms
From: erik.van.der.ven@philips.com
Date: Tue May 27 2003 - 06:42:53 PDT
Dear IBIS users,
It is possible to specify more than one waveform table, for instance with
different loads.
I have studied many IBIS models by semiconductor companies. All models I
have seen give only one waveform (both rising and falling).
What is the purpose of specifying more than one waveform? Does this yield
better results in the simulator if the load differs from the standard
load?
With kind regards,
Ir. Erik van der Ven
Room DB1032
Business Line Networking Infrastructure
Philips Semiconductors BV
Gerstweg 2
6534 AE Nijmegen
The Netherlands
Phone: +31-24-3534334
|------------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with just the appropriate command message(s) in the body:
|
| help
| subscribe ibis <optional e-mail address, if different>
| subscribe ibis-users <optional e-mail address, if different>
| unsubscribe ibis <optional e-mail address, if different>
| unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a written request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
| http://www.eda.org/pub/ibis/email_archive/ Recent
| http://www.eda.org/pub/ibis/users_archive/ Recent
| http://www.eda.org/pub/ibis/email/ E-mail since 1993
This archive was generated by hypermail 2b28 : Tue May 27 2003 - 08:47:04 PDT