[IBIS] [IBIS-Users] double Supply Voltage

Hi ibis experts,

In my Level traslator , I have  VCC1 in the input side
(where there is "in" Pin) and  VCC2 in the output side
(where there is "out" Pin) . With VCC1=1.8V and VCC2=2.9V.
In which way I can explain this condition?
is this correct?

[Pin]       signal_name      model_name     R_pin    L_pin    C_pin
|
in           in                       mod_in
out         out                     mod_out
VSS      VSS                    GND
VCC1   VCC1                 POWER
VCC2   VCC2                 POWER

Or I must use Pin Mapping ?

thank you for any possible response.

Regards,
Fabio



--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993