Subject: [IBIS-Users] On IBIS Model Generation
From: S Jairam (sjairam@ti.com)
Date: Mon Sep 16 2002 - 22:07:07 PDT
Hi,
This might sound very dumb a question, but I dont have an
answer to this.
When IBIS model generation for an IO buffer is in progress,
only one package load (a set of RLC parameters) is used to calculate
all the IV curves. Is that valid ? Because in such a case the
I-V curves of buffer would then be dependent of the package load.
Shouldn't it be that the calculation be done for various load
points with each load-point providing a set of I-V curves.
Please correct me if I am wrong.
Thanks and Regards,
Jairam.
-- # S.Jairam, # Texas Instruments Bangalore, # E-Mail: sjairam@ti.com # Phone : 080 5099 689 |------------------------------------------------------------------ |For help or to subscribe/unsubscribe, email majordomo@eda.org |with just the appropriate command message(s) in the body: | | help | subscribe ibis <optional e-mail address, if different> | subscribe ibis-users <optional e-mail address, if different> | unsubscribe ibis <optional e-mail address, if different> | unsubscribe ibis-users <optional e-mail address, if different> | |or email a written request to ibis-request@eda.org. | |IBIS reflector archives exist under: | | http://www.eda.org/pub/ibis/email_archive/ Recent | http://www.eda.org/pub/ibis/users_archive/ Recent | http://www.eda.org/pub/ibis/email/ E-mail since 1993
This archive was generated by hypermail 2b28 : Mon Sep 16 2002 - 22:30:38 PDT