hi IBIS users I have generated the ibis model of an I/O pad. Is there any way through which I can be sure that the table generated is correct? In short, I wanted to know that what sort of validation procedure/technique is done on any ibis model. -- thanks sujit kumar +91-120-4396069 +91-09910168788 -------------------------------------------------------------------- |For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org |with the appropriate command message(s) in the body: | | help | subscribe ibis <optional e-mail address, if different> | subscribe ibis-users <optional e-mail address, if different> | unsubscribe ibis <optional e-mail address, if different> | unsubscribe ibis-users <optional e-mail address, if different> | |or e-mail a request to ibis-request@eda-stds.org. | |IBIS reflector archives exist under: | | http://www.eda-stds.org/pub/ibis/email_archive/ Recent | http://www.eda-stds.org/pub/ibis/users_archive/ Recent | http://www.eda-stds.org/pub/ibis/email/ E-mail since 1993Received on Tue Dec 26 02:10:36 2006
This archive was generated by hypermail 2.1.8 : Tue Dec 26 2006 - 02:12:39 PST