Please use s2ibis3. A number of bugs and algorithm errors were fixed in that release. If you need help with s2ibis3, please read the documentation on the NCSU site. If you need additional support, please contact Ambrish Varma (cc on this email). Best regards, Lynne "IBIS training when you need it, where you need it." Dr. Lynne Green Green Streak Programs http://www.greenstreakprograms.com 425-788-0412 lgreen22@mindspring.com _____ From: owner-ibis-users@eda.org [mailto:owner-ibis-users@eda.org] On Behalf Of rrwolff@micron.com Sent: Wednesday, May 30, 2007 4:08 PM To: hngo@atrua.com; ibis-users@eda.org Subject: [IBIS-Users] RE: Need help with GND_Clamp and POWER_Clamp Sorry, I've never used the s2ibis2 script. Can anyone else on this list please help? Thanks, Randy _____ From: Hung Ngo [mailto:hngo@atrua.com] Sent: Wednesday, May 30, 2007 4:27 PM To: rrwolff; ibis-users Subject: Need help with GND_Clamp and POWER_Clamp Hello Randy, I am a beginner at IBIS. I downloaded the free tools from IBIS homepage and try to generate the models for the first time. So far so good but the example script (http://www.vhdl.org/pub/ibis/s2ibis/s2ibis2_v1.1/) does not include GND_clamp and POWER_clamp. Is there any other scripts or examples you can tell me so I can complete my IBIS models quickly? My question to you is: 1/ when I sweep the supply range for GND_clamp from -VDD to +VDD, should I tie the Pad to VSS or to VDD? 1/ when I sweep the supply range for POWER_clamp from -VDD to 0V, should I tie the Pad to VSS or to VDD? Your help is greatly appreciated. Thank you Randy. Hung Ngo Atrua Technologies 1696 Dell Avenue Campbell, CA 95008 (408) 370-8015 -- This message has been scanned for viruses and dangerous content by <http://www.mailscanner.info/> MailScanner, and is believed to be clean. -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -------------------------------------------------------------------- |For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org |with the appropriate command message(s) in the body: | | help | subscribe ibis <optional e-mail address, if different> | subscribe ibis-users <optional e-mail address, if different> | unsubscribe ibis <optional e-mail address, if different> | unsubscribe ibis-users <optional e-mail address, if different> | |or e-mail a request to ibis-request@eda-stds.org. | |IBIS reflector archives exist under: | | http://www.eda-stds.org/pub/ibis/email_archive/ Recent | http://www.eda-stds.org/pub/ibis/users_archive/ Recent | http://www.eda-stds.org/pub/ibis/email/ E-mail since 1993
This archive was generated by hypermail 2.1.8 : Wed May 30 2007 - 18:07:49 PDT