[IBIS-Users] IV curves w.r.t. Rfixture / Rload

From: Chetana Raghuwanshi <chetana.raghuwanshi_at_.....>
Date: Thu Feb 07 2008 - 06:29:44 PST
Hello All,

I am generating IBIS Models ( based on 2.0 Format) for a bidirectional  IO
cell with output impedence of 32 Ohms.

Customer specification is to use Rfixture/Rload value of 50 Ohms for IBIS
Models.

But when I see my pullup and pulldown I-V curves, the loadline corresponds
to the Resistive load of 32 Ohms which is nothing but the output impedence
of driver in my Bidir cell.

I think that the pullup and pulldown I-V curves should correspond to
Resistive Load of 50 Ohms. Am I correct in assuming this ?

Or is it expected that irrespective of the value of Rfixture / Rload pullup
and pulldown curves should correspond to Zout of driver ?



Thanks in Advance

Best Regards

Chetana

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.



--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Thu Feb 7 06:28:54 2008

This archive was generated by hypermail 2.1.8 : Thu Feb 07 2008 - 06:29:13 PST