Hello Experts, I have a driver with Slope control circuit at output pin. This circuit controls driver behaviour according to the Load on output pin. IBIS model of this buffer has only R_fixture but when I am simulating IBIS model with certain capacitive load then IBIS is not able to produce exact SPICE behaviour. My observation for mismatch is dynamic behavior of Slope control circuit with load which I am not able to model in IBIS. My question is how can I model the dynamic behaviour of Slope control circuit in IBIS ? Regards Prabhat -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -------------------------------------------------------------------- |For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org |with the appropriate command message(s) in the body: | | help | subscribe ibis <optional e-mail address, if different> | subscribe ibis-users <optional e-mail address, if different> | unsubscribe ibis <optional e-mail address, if different> | unsubscribe ibis-users <optional e-mail address, if different> | |or e-mail a request to ibis-request@eda-stds.org. | |IBIS reflector archives exist under: | | http://www.eda-stds.org/pub/ibis/email_archive/ Recent | http://www.eda-stds.org/pub/ibis/users_archive/ Recent | http://www.eda-stds.org/pub/ibis/email/ E-mail since 1993Received on Wed Aug 27 12:30:11 2008
This archive was generated by hypermail 2.1.8 : Wed Aug 27 2008 - 12:31:08 PDT