Re: [IBIS-Users] Error message from IBIS parser.

Hello Anguraj,

I'm not an expert, but I have encountered this a few times.
I usually try (either of) the following:
1) Run the simulation for a little bit longer
2) Increase R_fixture (or add another curve)

Best regards,  Lars Snith


Anguraj.K wrote:
> Hi IBIS Experts,
> 
> A quick help!
> 
> When do I get this  ERROR message fron ibis parser (ibischk3)?
> The [Rising Waveform]
>      with [R_fixture]=50 Ohms and [V_fixture_min]=1.71V
>      has MIN column DC endpoints of  0.86V and  1.59v, but
>      an equivalent load applied to the model's I-V tables yields
>      different voltages ( 0.82V and  1.49V),
>      a difference of  6.87% and 14.93%, respectively.
> 
> Any input would be of great help!
> 
> Thanks,
> Anguraj

-- 
Those who can, Do
Those who can't, Simulate
--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993